返回首页 公司简介 产品展示 产品色卡 新闻中心 行业动态 在线留言 联系我们
  环氧树脂地坪工程系列
     环氧树脂砂浆滚涂地坪
     环氧树脂自流平地坪
     环氧砂浆自流平地坪
     环氧树脂水性地坪
     环氧树脂滚涂地坪
  耐磨地坪工程系列
     水泥自流平地坪
     压模地坪
     金刚砂耐磨地坪
     混凝土密封固化剂
  防静电地坪工程系列
     环氧防静电自流平地坪
     环氧防静电薄涂地坪
     全钢高架防静电地板
     PVC防静电地板
  工业防腐地坪工程系列
     防腐玻纤型环氧地坪
     乙烯基酯重防腐地坪
  地下停车场地坪工程系列
     停车场地坪
     无震动止滑车道
  运动场地坪工程系列
     PU球场
     PU跑道
  无锡市名轩装饰材料有限公司
地 址:无锡高新技术开发区鸿山镇
电 话:0510-66889376
传 真:0510-88582949
邮 箱:mingxwx@163.com
冯士军:13506190899
网 址:http://www.mingx-wx.com
 
当前位置 -> 首页新闻资讯环氧地坪施工常见硬伤的应对方法一 发布时间:(2019/2/22)

环氧地坪施工常见硬伤的应对方法一

 

环氧地坪是一种高强度、耐磨损、美观的地板,具有无接缝、质地坚实等优点。环氧地坪在施工过程中,经常会遇到一些问题,影响着施工效果。对于这些比较常见的施工问题,会直接导致环氧地坪施工效果下降。环氧地坪施工过程中比较常见的问题主要有八种情况,都会对施工效果产生或大或小的影响。我们该如何进行施工,避免这几种问题的出现。

Epoxy floor is a kind of floor with high strength, wear resistance and beautiful appearance. It has the advantages of seamless and solid texture. During the construction of epoxy floor, some problems often occur, which affect the construction effect. For these common construction problems, the construction effect of epoxy floor will be reduced directly. There are eight common problems in the construction of epoxy flooring, which will have a big or small impact on the construction effect. How should we carry out construction to avoid these problems? 

漆面比较毛糙

Coarse finish 

新上漆的表面毛糙,通常是所用的漆刷不干净环氧树脂漆 或受周围环境污染造成的。也有可能是油漆中混有漆皮,在使用前未经沉淀和过滤,或油漆未干时沾上了灰尘。为防止发生上述问题,必须采用干净的漆刷和漆桶。旧漆使用前,一定要用滤纸或干净的尼龙丝袜过滤。另外,漆好的表面在油漆未干时要用罩子或硬纸板遮住,以防沾上灰尘。如果漆面毛糙,待其干透后,用干湿两用砂纸打磨光滑、擦净后,再重新刷上油漆。要特别注意漆刷必须是干净的。

The newly painted surface is rough, usually because the brush used does not clean epoxy paint or is caused by environmental pollution. It may also be that the paint is mixed with paint, which has not been precipitated and filtered before use, or is covered with dust when the paint is not dry. To prevent these problems, clean brushes and buckets must be used. Before using the old paint, it must be filtered with filter paper or clean nylon stockings. In addition, the painted surface should be covered with a cover or cardboard when the paint is not dry to prevent dust. If the surface of the paint is rough, after it is dried out, polish it with dry and wet sandpaper, then brush it again. Special attention should be paid to the fact that the paint brushes must be clean. 

油漆起泡

Paint blistering 

首先,用尖物把泡刺破,如果有水冒出来,即说明漆层底下或者背后有潮气渗入,经太阳一晒,水分蒸发成蒸气,就会把漆皮顶起成泡。此时,先用热风喷枪除去起泡的油漆,让木料自然干燥,然后刷上底漆,最后再在整个修补面上重新上漆。若泡中无水,就可能是木纹开裂,内有少量空气,经太阳一晒,空气膨胀,漆皮就鼓起了。面对这种情况,先刮掉起泡的漆皮,再用树脂填料填平裂纹,重新上漆,或不用填料,在刮去漆皮后,直接涂上微孔漆。

First, puncture the bubbles with sharp objects. If water comes out, it means that there is moisture under or behind the paint layer. When the water evaporates into vapor after sunshine, it will bubbles the top of the paint. At this time, first remove the foaming paint with hot air spray gun, let the wood dry naturally, then brush the primer, and finally re-paint the entire repair surface. If there is no water in the bubbles, it may be wood grain cracking, with a small amount of air in it. When the sun shines, the air expands and the paint bulges. Faced with this situation, first scrape off the foaming paint, then fill the cracks with resin filler, re-paint, or no filler, after scraping off the paint, directly coat with micro-porous paint. 

上漆了却没有光泽

Painted but not glossy 

没有上底漆或底漆及内层漆还没干就直接上有光漆都会导致没有光泽的情况。其次有光漆的质量不好也是一个原因。解决方法是用干湿两用砂纸把旧漆磨掉,刷去打磨的灰尘,用干净湿布把表面擦净,待干透后,再重新刷上面漆。还有一点要特别注意的是,在气温很低的环境下涂漆,漆膜干后也可能会失去光泽。

The absence of primer or primer and direct varnish before the inner paint is dry can lead to a lack of luster. Secondly, the poor quality of varnish is also a reason. The solution is to use wet and dry sandpaper to rub off the old paint, brush off the polished dust, wipe off the surface with a clean wet cloth, and then brush the paint again after drying out. It is also important to pay special attention to the fact that the film may lose its luster after drying when it is painted in a very low temperature environment. 



来源:  浏览次数:172
相关阅读:施工时注意这几点环氧地坪质量会更好 | 环氧地坪施工质量问题分析综述 | 艺术压模地坪的特点。
 
版权所有:无锡市名轩装饰材料有限公司   地址:无锡高新技术开发区鸿山镇   电话:0510-66889376  传真:0510-88582949
邮箱:mingxwx@163.com  冯士军:13506190899  网 址:http://www.mingx-wx.com 苏ICP备12054068号-1